Tokyo University of Agriculture and Technology

Proposal of formation of tapered micro-hole by utilizing electrolyte flow in ECM process

David Billington2018-08-17T13:38:19+00:00

Study on effect of lead and tilt angle of tool on cutting force and tool wear in turn milling

Analysis,End milling,Turning

David Billington2018-08-17T13:38:19+00:00

Optimization of grinding conditions for small diameter hole to achieve higher performance of linear solenoid

Accuracy,Grinding,Machining,Tool

David Billington2018-08-17T13:37:51+00:00

Observation of phenomenon in gap area during hole drilling with micro EDM

euspen2018-04-04T13:57:31+00:00

Influence of tool material and electrolyte on characteristics of Wire ECM with raised low-level voltage

euspen2018-04-04T13:57:45+00:00

Clarification and Solution of Depth-dependent Tool Wear and Removal Rate in Micro Electrical Discharge Drilling

euspen2018-04-04T13:58:58+00:00

Proposal of Electrolyte Suction Tool Electrode for Machining Area Confinement and Gap-width Detection

euspen2018-04-04T13:58:58+00:00

5-Axis Control Ultraprecision Dexterous Micromachining of Möbius Ring

euspen2018-04-04T13:59:03+00:00

Micro machining of glass with ultrasonic-vibration table

euspen2018-04-04T13:59:05+00:00

On-demand surface enhancements by friction stir burnishing

euspen2018-04-04T13:59:54+00:00

Previous 123 Next

Translate »